Derating Curve
Pulse Withstanding Chip Resistors

Environmental Characteristics
Test Item Specification Test Method
Short Time Overload ±0.5% JIS-C-5202-5.5
RCWV*2.5 or Max Overloading Voltage, 5 seconds
Thermal Shock ±0.5% MIL-STD-202F Method 107G
-55°C~150°C, 100 cycles
Temperature Coefficient of Resistance As Spec. MIL-STD-202F Method 304
Load Life ±1% MIL-STD-202F Method 108A
RCWV, 70°C, 1.5 hours ON, 0.5 hours OFF,
total 1000~1048 hours
(Steady State)
±0.5% MIL-STD-202F Method 103B
40°C, 90~95%RH, RCWV 1.5 hours ON,
0.5 hours OFF, total 1000~1048 hours
Resistance to Dry Heat ±0.5% JIS-C-5202-7.2
96 hours @ +155°C without load
Low Temperature Operation ±0.5% JIS-C-5202-7.1
1hour,-65°C followed by 45 minutes of RCWV
Bending Strength As Spec. JIS-C-5202-6.1.4
Bending Amplitude 3mm for 10 seconds
Resistance to
Soldering Heat
±0.5% MIL-STD-202F Method 210E
260±5°C, 10±1seconds
Solderability 95% min coverage MIL-STD-202F Method 208H
245°C±5°C, 3±0.5(sec)
Dielectric Withstand Voltage As Spec. MIL-STD-202F Method 301
Apply Max Overload Voltage for l minute
Insulation Resistance >1000MΩ MIL-STD-202F Method 302
Apply 100VDC for 1minute
Note: Storage Temperature: 25±3°C; Humidity: <80%RH

Lightning Surge
Pulse Withstanding Chip Resistors

Pulse Withstanding Chip Resistors
Note:Resistors are tested in accordance with IEC 60 115-1 using both 1.2/50us and 10/700 pulse.shapes. The limit of acceptance is a shift in resistance of less than 1% from the initial value.

How to Order
PWR 06 D TR C O 1000  
Part Number
Dimensions (L×W)
05 2.00×1.25mm EIA0805
06 3.05×1.55mm EIA1206
10 5.00×2.45mm EIA2010
12 6.30×3.10mm EIA2512
Resistance Tolerance
D ±0.5%
F ±1%
G ±2%
H ±3%
J ±5%
P Bulk
TR Taping Reel
C1 ±100ppm/°C
C ±200ppm/°C
Power Rating
A 1.5W
O 1/3W
Q 3/4W
T 1W
U 1/2W
V 1/4W
W 1/8W
1000 100Ω
2201 2200Ω
1002 10000Ω
1003 100000Ω
  Standard Marking for E96/E24
N No Marking

To Top Page
Page: 1 / 2 / 3

Direct Electronics Tech. Co., Ltd.
Taiwan Tel:+886-2-29810109 Fax:+886-2-29887487
China Tel:+86-755-26055363 Fax:+86-755-26055365